Usage Guidelines

Follow these professional tips for the best results and to ensure your full deposit is returned.

✅ Universal Best Practices

🔹
Stable Power Supply: Always connect directly to a 230V wall outlet. If an extension is necessary, use only heavy-duty cables. Thin cords cause voltage drops that burn out motors.
🔹
The 45/15 Rule: To prevent overheating, give the equipment a 15-minute rest for every 45 minutes of continuous run time.
🔹
Pre-Start Purge: For pressure washers, always run water through the system before turning the power on to remove air pockets.
🔹
Filter Maintenance: Ensure intake filters (for washers) or dust bags (for vacuums) are clear of debris to maintain maximum performance.

🚫 Prohibited Actions

❌
Dry Running: Never operate pumps or motors without their required medium (water for washers / proper airflow for vacuums). This causes instant internal damage.
❌
Contaminated Sources: Use only clean tap water for washers. Never use pond, well, or muddy water as silt will destroy the internal valves.
❌
Chemical Misuse: Do not add bleach, flammable liquids, or corrosive acids into any detergent tanks or vacuum drums.
❌
Weather Hazards: Do not operate electrical equipment during heavy rain or thunderstorms. Store equipment in a dry, covered area when not in use.

Equipment-Specific Guidelines

Detailed instructions for each piece of equipment in our fleet.

🚿 Pressure Washer (1700W, 120 Bar)

Pre-Start: Connect water supply first, purge air by running water through gun before powering on.
Nozzle Distance: Keep spray gun 30-50cm from surface. Closer = higher risk of paint/tile damage.
Hose Care: Never kink or drive over the 8m steel-reinforced hose. Avoid sharp edges.
Water Source: Use only clean tap water. Muddy/well water will clog valves.
Post-Use: Release pressure by squeezing trigger before turning off. Drain remaining water.

🧹 Wet & Dry Vacuum (30L, 1200W)

Wet Mode: Remove dust bag/filter before vacuuming liquids. Empty drum immediately after wet use.
Dry Mode: Ensure filter is installed and clean. Empty when drum reaches 80% capacity.
Prohibited: Never vacuum hot ashes, sharp metal fragments, or flammable liquids.
Blower Function: Reverse hose to outlet port. Use for drying or clearing debris.
Maintenance: Clean foam filter after each use. Wipe stainless drum dry before storage.

🪜 Aluminium Ladder (7ft, 150kg Max Load)

Setup: Always place on flat, stable ground. Lock spreader bars fully before climbing.
Weight Limit: Maximum load 150kg (person + tools). Do not exceed.
Climbing: Face the ladder, maintain 3-point contact (2 hands + 1 foot, or 2 feet + 1 hand).
Prohibited: Do not place near power lines, use during rain, or lean sideways while on ladder.
Storage: Fold carefully, store in dry area. Check for loose bolts before each use.

🔊 JBL PartyBox Club 120 (120W Speaker)

Power: Fully charge before first use. Battery lasts up to 12 hours at moderate volume.
Volume: Start at 30-40% volume and adjust. Max volume drains battery faster.
Water Resistance: Splash-proof only. Do not submerge or expose to heavy rain.
Connections: Supports Bluetooth, USB, Aux-in, and dual mic/guitar inputs. Pair via Bluetooth for best quality.
Transport: Use built-in handles. Protect from impacts. Do not leave in direct sun for extended periods.

📷 GoPro Hero 13 Black (5.3K Action Camera)

SD Card: 64GB SanDisk included. Format before first use via camera settings.
Battery: Charge fully (approx 2 hours). Spare batteries available on request.
Waterproof: Rugged design, waterproof to 10m without housing. Rinse with fresh water after ocean use.
Recording: 5.3K60 for high detail, 1080p240 for slow-motion. Check remaining storage before important shots.
Care: Wipe lens with microfiber cloth only. Avoid touching sensor screen with dirty/wet hands.

⚠️

A Note on Professional Care:

Most modern equipment has thermal sensors and diagnostic logs. Damage caused by bypass-operation, dry-running, electrical surges, or misuse is easily detectable by our technicians. Please follow the on-site demo instructions carefully to avoid liability for repair costs.